OCCUPATIONAL SAFETY AND HEALTH
Instructions on labor protection for the machine operator of the MMSK-2 machine. Full document Occupational Safety and Health / Standard instructions for labor protection Safe Operation 1. General requirements for labor protection 1.1. Persons at least 18 years of age who have passed a medical examination, instruction and training in working with this equipment are allowed to work. 1.2. Teenagers under 18, as well as nursing mothers and pregnant women are not allowed to work. 1.3. Glue preparation should be carried out in a specially prepared room, in which there should be no more than 2 people, with the hood turned on. 1.4. The supply of glue at the workplace should not exceed the replacement requirement. The container from under glue and solvent after emptying has to be removed. 1.5. It is forbidden to smoke, use open fire and perform work in the process of which sparks may form in the room with automatic machines. All work related to welding is carried out according to the order approved by the chief engineer of the enterprise. 1.6. Used cleaning materials should be collected in special, tightly closed boxes. The boxes should be emptied once per shift, and the contents should be incinerated. 1.7. An asbestos sheet should be located on the site in case of extinguishing a fire in a fire. 1.8. Perform only the work that you are assigned by the administration. 1.9. Persons who violate the requirements of the instructions are liable in accordance with the legislation of the Russian Federation. 2. Labor protection requirements before starting work 2.1. Familiarize yourself with the operation manual of the machine, follow the technical instructions set out in the manual in work in order to avoid emergencies and accidents. 2.2. Put on overalls, fasten sleeves, avoid hanging and fluttering ends that can be caught by rotating parts of the equipment. 2.3. Tidy up the workplace. 2.4. Check the serviceability and availability of protective fences, devices and grounding of the machine. Do not work on the machine without casings covering the drive belts. 2.5. Make sure the workplace is well lit. Ventilate the room 6 minutes before starting work. 2.6. Turn on the extractor. 3. Labor protection requirements during work 3.1. Avoid clutter at the workplace, do not accumulate finished products near the equipment. 3.2. Constantly monitor the serviceability of equipment, tools, fencing, grounding, operation of the exhaust device. 3.3. Avoid congestion and clutter aisles. 3.4. It is forbidden to make adjustments to the mechanisms of the machine while the equipment is in operation. 3.5. Cleaning and wiping the machine, as well as adjusting the mechanisms should be done only after the machine has stopped, while the machine must be disconnected from the mains. 3.6. Operate the machine only when the ventilation is switched on. 3.7. During work, use personal protective equipment - a respirator, hand ointment, use a tool that does not cause sparks. 3.8. Place dirty oil ends and rags in a metal box with a lid, do not scatter rags around the workshop and near the machine. 4. Labor protection requirements in emergency situations 4.1. Turn off the equipment and inform the master about it, do not carry out independent repairs. 4.2. Do not start working on the machine until the faults are completely eliminated. 4.3. In case of fire, use a powder or carbon dioxide fire extinguisher to extinguish electrical equipment. If the adhesive mass ignites, extinguish the fire with a powder fire extinguisher. Report the fire to the foreman immediately. 4.4. In case of injury, immediately notify the management and organize first aid for the injured. 5. Labor protection requirements at the end of work 5.1. Switch off the machine. 5.2. Clean the workplace, clean the machine. Cleaning should be carried out with a wet method. 5.3. Tidy up your workspace. Remove the remaining adhesive mass in the place provided for this. 5.4. Dispose of waste in a container. 5.5. Place the finished product in a specially designated place. 5.6. Take off overalls. 5.7. Wash hands with warm water and soap. We recommend interesting articles Section Standard instructions for labor protection: ▪ Duty officer at a construction site. Standard instruction on labor protection ▪ Slinger. Standard instruction on labor protection ▪ Work on fiber-optic communication cables. Standard instruction on labor protection See other articles Section Standard instructions for labor protection. Read and write useful comments on this article. Latest news of science and technology, new electronics: Artificial leather for touch emulation
15.04.2024 Petgugu Global cat litter
15.04.2024 The attractiveness of caring men
14.04.2024
Other interesting news: ▪ Mushrooms help recycle plastic waste ▪ The distance of ultrashort flashes of light is calculated ▪ 10-storey house built in a day ▪ Lenovo Legion R7000P and R9000P gaming laptops News feed of science and technology, new electronics
Interesting materials of the Free Technical Library: ▪ section of the site Encyclopedia of radio electronics and electrical engineering. Article selection ▪ article by Stanislas de Boufleur. Famous aphorisms ▪ article What is the fun of kings? Detailed answer ▪ article stacker-packer. Standard instruction on labor protection
Leave your comment on this article: All languages of this page Home page | Library | Articles | Website map | Site Reviews www.diagram.com.ua |