Shaving products. simple recipes

Free technical library

FACTORY TECHNOLOGIES AT HOME - SIMPLE RECIPES
Free library / Directory / Factory technology at home - simple recipes

Shaving products. Simple recipes and tips

Factory technologies - simple recipes

Directory / Factory technology at home - simple recipes

Comments on the article

Here are a few different recipes shaving products.

Soapy shaving creams

1st recipe:

Coconut oil 2 kg;
Stearic acid (double or triple pressing) 9 kg;
Caustic potash 30 °Be 6 kg;
Glycerin 3,6 kg;
Water 3 l.

Coconut oil and glycerin are placed in a kettle, heated to 50 °C and stirred thoroughly. Then slowly add half the potash little by little and stir thoroughly until a thick mass is obtained. After this, pour the rest of the potash into the cauldron and add the rest of the water, stirring continuously. Potash and water are added in small portions. Separately, melt the stearic acid in a clean enamel vessel and slowly pour it into the cauldron in a thin stream, continuously stirring until a uniform mass is obtained. You need to stir continuously, but not too much, so as not to foam the cream. The contents of the cauldron are left for a day, after which you can add a little aromatic oil for scent, stirring carefully. This composition can be poured into tubes.

2st recipe:

The best soap 140 g;
Rose water 220 g;
Coconut oil 28 g;
Almond oil 28 g.

Dissolve soap in rose water when heated. Separately dissolve the coconut oil in the almond oil by heating. Both solutions are mixed hot and while stirring, add 1,7 g of benzoin and 5 drops of almond oil. After that, glycerin is added in sufficient quantity to obtain a cream of density and knocked down until it cools.

White soap 1 kg;
Almond oil 100 g;
Wine alcohol 500 g;
Rose water 500 g;
Amber liquid 10 g;
Benzoic liquid 10 g.

Helle shaving cream

Solid paraffin 44 g;
Lamb fat 6 g;
Potassium soap 4 g;
Distilled water 136 g;
Tragacanth powder 4 g;
Glycerin 4 g.

Paraffin, mutton fat and potassium soap are placed in a vessel and doused with distilled water. The vessel is carefully placed in boiling water, and stirred until a milky emulsion is obtained. After a slight cooling, gradually add, stirring, powdered tragacanth and glycerin.

The cream can be flavored with any perfume oil.

Shaving soap bars

1st recipe:

Here are 2 recipes.
Castile soap powder 400 g;
Rose water 500 cm3;
Cocoa butter 50 g;
Soda 25 g;
Glycerin 100 g.

All parts are mixed, heated for 30 minutes and poured into molds.

2st recipe:

Lamb fat 800 g;
Coconut oil 400 g;
Caustic soda 30 °Be 680 g;
Caustic potassium 30 °Be 120 g;
Coumarin 4 g;
Bergamot oil 5 g;
Lavender oil 3 g;
Thyme oil 2 g;
Mirbanov essence 5 g.

Melt the lamb fat and coconut oil, let it cool to 50 °C, add caustic soda and potassium and stir over low heat until a homogeneous soap glue is obtained and then mix in the remaining substances. When cooled, cut into pieces of the desired format, allow them to air dry a little and wrap in tin foil.

Soap powder for shaving

The best soap powder 400 g;
Borax 50 g;
Almond bran 25 g;
Stir. ;
Cream used after shaving;
Coconut oil 400 g;
Menthol crystal 10 g;
Rose water 75 g.

Melt the butter in a water bath, remove from heat, add menthol and gradually add rose water. Stir thoroughly until cool, and place in tubes of 100 g.

Eau de toilette after shave

Menthol 1,7 g;
Boric acid 70 g;
Glycerin 140 g;
Alcohol 2,5 liters.

Menthol is placed in a 20-liter glass bottle, alcohol is poured in, boric acid, aromatic oil (of the desired smell) and glycerin are added. Then the entire composition is shaken until all parts are completely dissolved, after which water is added until a total amount of eau de toilette is 20 l and filtered through filter paper. Can be painted in the desired color with paint. Preferred color is green.

After shaving, use like any toilet water.

Antiseptic stones used after shaving

1st recipe:

Ordinary potassium aluminum alum is dissolved in an equal amount of water and this solution is evaporated until all the added water is removed.

A small amount of glycerin, sublimate and menthol is added to the condensed solution. The hot mixture is poured into tin molds, and after hardening, the sharp edges of the hardened crystalline mass are polished with water.

2st recipe:

According to Rode's recipe, alum is melted in a water bath, without adding water. (At 92 °C, alum melts in its water of crystallization). 5% borax, 1% glycerin, 0,5% zinc oxide and 1% formaldehyde are added to the molten mass. The mass is mixed and poured into molds. Forms are usually used with folding walls.

Author: Korolev V.A.

We recommend interesting articles Section Factory technology at home - simple recipes:

▪ Gray mordant for horn

▪ Filter suede

▪ Resin ester varnishes

See other articles Section Factory technology at home - simple recipes.

Read and write useful comments on this article.

<< Back

Latest news of science and technology, new electronics:

Air trap for insects 01.05.2024

Agriculture is one of the key sectors of the economy, and pest control is an integral part of this process. A team of scientists from the Indian Council of Agricultural Research-Central Potato Research Institute (ICAR-CPRI), Shimla, has come up with an innovative solution to this problem - a wind-powered insect air trap. This device addresses the shortcomings of traditional pest control methods by providing real-time insect population data. The trap is powered entirely by wind energy, making it an environmentally friendly solution that requires no power. Its unique design allows monitoring of both harmful and beneficial insects, providing a complete overview of the population in any agricultural area. “By assessing target pests at the right time, we can take necessary measures to control both pests and diseases,” says Kapil ... >>

The threat of space debris to the Earth's magnetic field 01.05.2024

More and more often we hear about an increase in the amount of space debris surrounding our planet. However, it is not only active satellites and spacecraft that contribute to this problem, but also debris from old missions. The growing number of satellites launched by companies like SpaceX creates not only opportunities for the development of the Internet, but also serious threats to space security. Experts are now turning their attention to the potential implications for the Earth's magnetic field. Dr. Jonathan McDowell of the Harvard-Smithsonian Center for Astrophysics emphasizes that companies are rapidly deploying satellite constellations, and the number of satellites could grow to 100 in the next decade. The rapid development of these cosmic armadas of satellites can lead to contamination of the Earth's plasma environment with dangerous debris and a threat to the stability of the magnetosphere. Metal debris from used rockets can disrupt the ionosphere and magnetosphere. Both of these systems play a key role in protecting the atmosphere and maintaining ... >>

Solidification of bulk substances 30.04.2024

There are quite a few mysteries in the world of science, and one of them is the strange behavior of bulk materials. They may behave like a solid but suddenly turn into a flowing liquid. This phenomenon has attracted the attention of many researchers, and we may finally be getting closer to solving this mystery. Imagine sand in an hourglass. It usually flows freely, but in some cases its particles begin to get stuck, turning from a liquid to a solid. This transition has important implications for many areas, from drug production to construction. Researchers from the USA have attempted to describe this phenomenon and come closer to understanding it. In the study, the scientists conducted simulations in the laboratory using data from bags of polystyrene beads. They found that the vibrations within these sets had specific frequencies, meaning that only certain types of vibrations could travel through the material. Received ... >>

Random news from the Archive

A healthy and effective replacement for morning coffee 04.12.2023

American scientists from the University of Georgia have presented a new look at morning wakefulness, offering an effective alternative to traditional coffee. A study of college students found that physical activity may provide the energy boost it needs even better than caffeine.

The experiment showed that active morning movement can be as effective as morning coffee in stimulating energy and increasing performance. Physical activity is a healthy alternative that can not only awaken the body, but also improve overall motivation to complete tasks.

To test this theory, scientists conducted an experiment with volunteers suffering from lack of sleep. Groups of subjects took caffeine, a placebo or soda, or climbed stairs for 10 minutes in the morning.

The study found that caffeine, placebo, and soda did not provide a significant boost in energy. While physical activity, such as climbing stairs, gave participants a boost of energy and stimulated motivation to be productive.

Other interesting news:

▪ Water and oil mix

▪ Thubber: super elastic rubber with metal properties

▪ Photon from a nanotube

▪ Icebreakers must sail backwards

▪ Scanner-keychain of Internet sites addresses

News feed of science and technology, new electronics

Interesting materials of the Free Technical Library:

▪ section of the site Standard instructions for labor protection (TOI). Selection of articles

▪ article Plant (plant) in a galosh. Popular expression

▪ article In which countries is Khoja Nasreddin a folklore anti-hero? Detailed answer

▪ article art editor. Job description

▪ article Antennas GP + WARC bands. Encyclopedia of radio electronics and electrical engineering

▪ article Microcircuits. operational amplifiers. Encyclopedia of radio electronics and electrical engineering

Leave your comment on this article:

All languages of this page

Home page | Library | Articles | Website map | Site Reviews