Menu English Ukrainian russian Home

Free technical library for hobbyists and professionals Free technical library


ENCYCLOPEDIA OF RADIO ELECTRONICS AND ELECTRICAL ENGINEERING
Free library / Encyclopedia of radio electronics and electrical engineering / Electrician

Section 2. Sewerage of electricity

Overhead power lines with voltage above 1 kV. Passage of overhead lines along dams and dikes

Free technical library

Encyclopedia of radio electronics and electrical engineering / Rules for the installation of electrical installations (PUE)

Comments on the article Comments on the article

2.5.276. When overhead lines pass through dams, dikes, etc., any distances from undeviated and diverted wires to various parts of dams or dikes in normal operation of overhead lines must be no less than those given in table. 2.5.38.

The vertical distances in normal operation of overhead lines must be taken no less than those given in the table. 2.5.38:

  • at the highest air temperature without taking into account the heating of the wire by electric current for overhead lines of 500 kV and below;
  • at air temperature according to 2.5.17 without taking into account the heating of wires by electric current at the maximum permissible values ​​of the intensity of the electric and magnetic components of the electromagnetic field for a 750 kV overhead line;
  • at design linear ice load according to 2.5.55 and air temperature at ice according to 2.5.51.

Table 2.5.38. The shortest distances from overhead line wires to various parts of dams and dams

Parts of dams and dikes The smallest distance, m, at voltage VL, kV
Until 110 150 220 330 500 750
Ridge and slope edge 6 6,5 7 7,5 8 12
Inclined slope surface 5 5,5 6 6,5 7 9
The surface of water overflowing through the dam 4 4,5 5 5,5 6 7

2.5.277. When an overhead line passes through dams and dikes along which communication routes are laid, the overhead line must also meet the requirements for overhead lines when crossing and approaching the corresponding objects of communication routes.

In this case, the horizontal distances from any part of the support to the communication routes should be taken as for overhead lines in sections of a constrained route. Distances to pedestrian paths and sidewalks are not standardized.

It is not allowed to place wires within the clearance of buildings, as well as within the width occupied by elements of the contact network of electrified railways.

It is allowed to place wires within the road surface, pedestrian paths and sidewalks.

See other articles Section Rules for the installation of electrical installations (PUE).

Read and write useful comments on this article.

<< Back

Latest news of science and technology, new electronics:

A New Way to Control and Manipulate Optical Signals 05.05.2024

The modern world of science and technology is developing rapidly, and every day new methods and technologies appear that open up new prospects for us in various fields. One such innovation is the development by German scientists of a new way to control optical signals, which could lead to significant progress in the field of photonics. Recent research has allowed German scientists to create a tunable waveplate inside a fused silica waveguide. This method, based on the use of a liquid crystal layer, allows one to effectively change the polarization of light passing through a waveguide. This technological breakthrough opens up new prospects for the development of compact and efficient photonic devices capable of processing large volumes of data. The electro-optical control of polarization provided by the new method could provide the basis for a new class of integrated photonic devices. This opens up great opportunities for ... >>

Primium Seneca keyboard 05.05.2024

Keyboards are an integral part of our daily computer work. However, one of the main problems that users face is noise, especially in the case of premium models. But with the new Seneca keyboard from Norbauer & Co, that may change. Seneca is not just a keyboard, it is the result of five years of development work to create the ideal device. Every aspect of this keyboard, from acoustic properties to mechanical characteristics, has been carefully considered and balanced. One of the key features of Seneca is its silent stabilizers, which solve the noise problem common to many keyboards. In addition, the keyboard supports various key widths, making it convenient for any user. Although Seneca is not yet available for purchase, it is scheduled for release in late summer. Norbauer & Co's Seneca represents new standards in keyboard design. Her ... >>

The world's tallest astronomical observatory opened 04.05.2024

Exploring space and its mysteries is a task that attracts the attention of astronomers from all over the world. In the fresh air of the high mountains, far from city light pollution, the stars and planets reveal their secrets with greater clarity. A new page is opening in the history of astronomy with the opening of the world's highest astronomical observatory - the Atacama Observatory of the University of Tokyo. The Atacama Observatory, located at an altitude of 5640 meters above sea level, opens up new opportunities for astronomers in the study of space. This site has become the highest location for a ground-based telescope, providing researchers with a unique tool for studying infrared waves in the Universe. Although the high altitude location provides clearer skies and less interference from the atmosphere, building an observatory on a high mountain poses enormous difficulties and challenges. However, despite the difficulties, the new observatory opens up broad research prospects for astronomers. ... >>

Random news from the Archive

Laser satellite communications 07.12.2022

With the help of a new satellite, developed by engineers from the Massachusetts Institute of Technology (MIT), a new record for data transmission between satellites and the Earth has been set. The TeraByte InfraRed Delivery (TBIRD) terabit infrared transmission system used lasers to transfer huge amounts of data at speeds up to 100 gigabits per second (Gbps).

This data rate is much faster than most sky-to-ground connections. For example, SpaceX's Starlink satellite internet offers premium customers speeds of up to 500 Mbps. And the data transfer rate between the Earth and the International Space Station reaches around 600 Mbps. This makes the TBIRD system 200 times faster.

The main difference of the new system is the method of data transmission. While most satellites communicate with ground stations using radio waves, the TBIRD system uses laser light. It can transfer 1000 times more data in one session. However, lasers also have their drawbacks. A laser beam is much narrower than a radio wave and therefore requires a more precise position matching between transmitter and receiver. In addition, the light may be distorted by the atmosphere, in which case data may be lost.

It is with the aim of solving these problems that the TBIRD system was developed. The satellite contains three main ready-made components: a high-speed optical modem, an optical signal amplifier, and a storage device.

All of this is housed in a container the size of a shoe box. To solve the problem of data loss, a team of engineers developed a new version of the so-called ARQ (Automatic Repeat Request) protocol. This protocol allows the ground station receiver to notify the transmitter of certain data packets (frames) that the transmitter has missed so that the satellite can easily retransmit them.

With regard to alignment with position matching, the system does not use special hangers to align the laser beams. A special error signal system is provided that aligns the entire satellite so that the beam is clearly aimed at the receiver. According to representatives of the development team, this allows the use of smaller optical components in the system.

“If the signal disappears, we can retransmit the data, but if the retransmission is inefficient, that is, if we spend all the time sending retransmissions instead of transmitting new data, we can lose a lot of bandwidth,” said Kurt Schiller, TBIRD systems engineer. "In our ARQ protocol, the receiver informs which frames it received correctly, so it knows which frames need to be retransmitted."

Other interesting news:

▪ HP budget netbooks

▪ Asus Essence STX II and Asus Essence STX II 7.1 sound cards

▪ 300 GB freeze-ray optical disk storage system

▪ Ring Pet Tag gadget for finding a pet

▪ Brother ADS-1100W and ADS-1600W Compact Scanners

News feed of science and technology, new electronics

 

Interesting materials of the Free Technical Library:

▪ section of the website job descriptions. Article selection

▪ article Magic oven. Tips for the home master

▪ article What animals spray their feces with their tail like a propeller? Detailed answer

▪ Swiss article. Job description

▪ article Renewable Energy: Progressive Trends or Aggressive PR? Encyclopedia of radio electronics and electrical engineering

▪ article Features of establishing mixers. Encyclopedia of radio electronics and electrical engineering

Leave your comment on this article:

Name:


Email (optional):


A comment:





All languages ​​of this page

Home page | Library | Articles | Website map | Site Reviews

www.diagram.com.ua

www.diagram.com.ua
2000-2024