Low power amplifiers with electronic control. Encyclopedia of radio electronics and electrical engineering
Encyclopedia of radio electronics and electrical engineering / Transistor power amplifiers
Comments on the article
I have already mentioned that there is a certain European commercial organization called Philips. She produces all sorts of funny microcircuits, and we'll talk about two of them now.
The first one is TDA8551. The microcircuit is a bridge amplifier with an output power of 1 watt at a supply voltage of 5V. At the same time, the current consumption in silent mode is only 10 mA. The chip is made in an 8-pin package and does not require a heatsink, which allows it to be used in various small-sized devices. The microcircuit is equipped with protection against overheating, has an internal load connection delay circuit - so when you turn it on, you will not hear wheezing, farts and other wonderful music of transients.
Well, one more good thing that this microcircuit was equipped with is electronic volume control. However, what am I all in words, but in words - we look at the diagram.
Such a modest circuit, requiring mainly shunt capacitors, and then in an amount that a cat can cry without straining at all. Buttons S1 and S2 adjust the volume, switch SW1 - the operating mode of the amplifier. I must say that the selected volume level is maintained until the power is physically removed from the microcircuit. From the STANDBY mode, it will exit with the volume with which you left it before entering this mode. If, however, to tear off the power completely, then on the next power-up, the microcircuit starts with the position of the volume control corresponding to the gain level of -20dB. A plate with elements ... although, there are elements here ...
Designation in the diagram |
Nominal |
C1 |
100uFx10V |
C2 |
0,33 |
C3 |
0,1 |
C4 |
0,1 |
C5 |
200uFx10V |
|
|
R1 |
2,2kOhm |
|
|
DA1 |
TDA8551 |
The second chip is actually a double copy of the previous one. It - TDA8552. One package of this chip contains two identical amplifiers. The only difference is a slightly higher output power - 1,4 watts per channel. But, nevertheless, it also does not require a radiator and can be used anywhere. The switching scheme is as follows.
This microcircuit has one more difference - the presence of output number 4. This output allows you to control the connection of headphones (of course, when using the correct connector) and automatically reduce the output power and the current consumed from the power source. But, I didn’t draw it on the diagram - I’ll send you to the datasheet, otherwise you will become completely lazy.
Designation in the diagram |
Nominal |
C1 |
0,33 |
C2 |
0,33 |
C3 |
0,1 |
C4 |
0,1 |
C5 |
220uFx10V |
C6 |
220uFx10V |
C7 |
220uFx10V |
C8 |
220uFx10V |
C9 |
0,1 |
R1 |
2,2kOhm |
R2 |
2,2kOhm |
R3 |
1kOhm |
R4 |
1kOhm |
DA1 |
TDA8552 |
Publication: radiokot.ru
See other articles Section Transistor power amplifiers.
Read and write useful comments on this article.
<< Back
Latest news of science and technology, new electronics:
Machine for thinning flowers in gardens
02.05.2024
In modern agriculture, technological progress is developing aimed at increasing the efficiency of plant care processes. The innovative Florix flower thinning machine was presented in Italy, designed to optimize the harvesting stage. This tool is equipped with mobile arms, allowing it to be easily adapted to the needs of the garden. The operator can adjust the speed of the thin wires by controlling them from the tractor cab using a joystick. This approach significantly increases the efficiency of the flower thinning process, providing the possibility of individual adjustment to the specific conditions of the garden, as well as the variety and type of fruit grown in it. After testing the Florix machine for two years on various types of fruit, the results were very encouraging. Farmers such as Filiberto Montanari, who has used a Florix machine for several years, have reported a significant reduction in the time and labor required to thin flowers.
... >>
Advanced Infrared Microscope
02.05.2024
Microscopes play an important role in scientific research, allowing scientists to delve into structures and processes invisible to the eye. However, various microscopy methods have their limitations, and among them was the limitation of resolution when using the infrared range. But the latest achievements of Japanese researchers from the University of Tokyo open up new prospects for studying the microworld. Scientists from the University of Tokyo have unveiled a new microscope that will revolutionize the capabilities of infrared microscopy. This advanced instrument allows you to see the internal structures of living bacteria with amazing clarity on the nanometer scale. Typically, mid-infrared microscopes are limited by low resolution, but the latest development from Japanese researchers overcomes these limitations. According to scientists, the developed microscope allows creating images with a resolution of up to 120 nanometers, which is 30 times higher than the resolution of traditional microscopes. ... >>
Air trap for insects
01.05.2024
Agriculture is one of the key sectors of the economy, and pest control is an integral part of this process. A team of scientists from the Indian Council of Agricultural Research-Central Potato Research Institute (ICAR-CPRI), Shimla, has come up with an innovative solution to this problem - a wind-powered insect air trap. This device addresses the shortcomings of traditional pest control methods by providing real-time insect population data. The trap is powered entirely by wind energy, making it an environmentally friendly solution that requires no power. Its unique design allows monitoring of both harmful and beneficial insects, providing a complete overview of the population in any agricultural area. “By assessing target pests at the right time, we can take necessary measures to control both pests and diseases,” says Kapil ... >>
Random news from the Archive Cro-Magnon was smarter than us
18.08.2011
The conventional wisdom is that hominin brain volume has only increased in the past four million years.
However, Antoine Balzot, a French anthropologist from the National Museum of Natural History in Paris, comparing the volume of the skull in 14 fossil skulls up to 90 thousand years old and in 192 modern people, came to the conclusion that over the past 25 thousand years the human brain has decreased. In Cro-Magnons, who lived 12-40 thousand years ago, the brain volume was on average 1550, and in modern people - 1350 cubic centimeters.
True, Balso emphasizes, this does not necessarily mean that the Cro-Magnons were smarter than us: after all, it is not only the size of the brain, but also its structure.
|
Other interesting news:
▪ Yeast can filter lead
▪ Next generation visual processor Movidius Myriad 2
▪ Li-ion battery capacity doubled
▪ Hockey matches with a first-person view
▪ Looking for gravitons
News feed of science and technology, new electronics
Interesting materials of the Free Technical Library:
▪ site section Parameters of radio components. Article selection
▪ article The sleep of reason produces monsters. Popular expression
▪ article What is a hurricane? Detailed answer
▪ article Crane operator (driver) of a jaw logger. Standard instruction on labor protection
▪ article Beginner radio amateur. Radio. Encyclopedia of radio electronics and electrical engineering
▪ article Carthusian diver. physical experiment
Leave your comment on this article:
All languages of this page
Home page | Library | Articles | Website map | Site Reviews
www.diagram.com.ua
2000-2024