Power supply 220/4 volt 0,1 amp with automatic charger on the comparator. Encyclopedia of radio electronics and electrical engineering
Encyclopedia of radio electronics and electrical engineering / Chargers, batteries, galvanic cells
Comments on the article
The power supply unit is intended for power supply from a 220 V network with a voltage of 4 V of a low-power load (current not more than 100 mA) and recharging of three batteries of the NkHz-0,45 or NkHz-0,5 type with automatic shutdown of the charge mode.
When the unit is connected to the network, the green LED lights up if there is voltage. The battery charging process is controlled by the glow of the red LED (switch SA1 must be on). While the charging process is in progress, it will be constantly on, and at the end of the charge, the LED starts blinking and the interval of its glow will be less than a pause,
The circuit (Fig. 5.17) automatically monitors the charging process and eliminates damage to the batteries. If the unit is used only to power the device, then the charger can be turned off by switch SA1.
Compared to similar schemes published in the literature, this one contains fewer radioelements and is easier to manufacture.
The required output voltage of the power supply is set by resistor R2. The device is configured to set the charge current to 45 mA with resistor R4 from a range of 15, 18, 20 ohms.
For tuning, instead of batteries, a 2 Ohm resistor with a power of at least 3 W is connected to the contacts X2 / 2 and X68 / 1 in series with a milliammeter. In this case, the HL2 LED should be constantly on. After performing this operation, the operation of the comparator DA2 is checked. Why should a 2 ohm resistor (3 W) be connected to the contacts X2 / 2 and X150 / 0,5 in parallel with the oscilloscope.
Rice. 5.17 (click to enlarge)
Structurally, the power supply unit is made on a single-sided printed circuit board, placed in a housing from a standard source of the BP2-3 type, designed to power microcalculators. A network transformer of the T8-220-50 type was also taken from the same source. When using a transformer of another type, its secondary winding must be designed for a voltage of 12 ... 15 V at a load current of 200 mA. LEDs HL1 and HL2 are attached to the top cover of the housing with glue. Plug X1 is made on the base of the body, and X2 is connected to the body with a wire about 1 m long.
Inside the case, a heat-dissipating plate is attached to the transistor VT1. The applied resistors can be of any type, capacitors C1 ... C3 - type K50-16 or similar small-sized, microswitch SA1 - type PD-9-2. Transistor VT1 can be replaced with KT814B.
When using the above parts, the dimensions of the entire device do not exceed 60x60x50 mm (Figure 5.18).
Rice. 5.18. Appearance of the device
To charge batteries of another type or a larger number of them, it is necessary to set the appropriate rated charge current (R4), upper (R2) and lower threshold (R8) of the comparator operation.
Publication: cxem.net
See other articles Section Chargers, batteries, galvanic cells.
Read and write useful comments on this article.
<< Back
Latest news of science and technology, new electronics:
Machine for thinning flowers in gardens
02.05.2024
In modern agriculture, technological progress is developing aimed at increasing the efficiency of plant care processes. The innovative Florix flower thinning machine was presented in Italy, designed to optimize the harvesting stage. This tool is equipped with mobile arms, allowing it to be easily adapted to the needs of the garden. The operator can adjust the speed of the thin wires by controlling them from the tractor cab using a joystick. This approach significantly increases the efficiency of the flower thinning process, providing the possibility of individual adjustment to the specific conditions of the garden, as well as the variety and type of fruit grown in it. After testing the Florix machine for two years on various types of fruit, the results were very encouraging. Farmers such as Filiberto Montanari, who has used a Florix machine for several years, have reported a significant reduction in the time and labor required to thin flowers.
... >>
Advanced Infrared Microscope
02.05.2024
Microscopes play an important role in scientific research, allowing scientists to delve into structures and processes invisible to the eye. However, various microscopy methods have their limitations, and among them was the limitation of resolution when using the infrared range. But the latest achievements of Japanese researchers from the University of Tokyo open up new prospects for studying the microworld. Scientists from the University of Tokyo have unveiled a new microscope that will revolutionize the capabilities of infrared microscopy. This advanced instrument allows you to see the internal structures of living bacteria with amazing clarity on the nanometer scale. Typically, mid-infrared microscopes are limited by low resolution, but the latest development from Japanese researchers overcomes these limitations. According to scientists, the developed microscope allows creating images with a resolution of up to 120 nanometers, which is 30 times higher than the resolution of traditional microscopes. ... >>
Air trap for insects
01.05.2024
Agriculture is one of the key sectors of the economy, and pest control is an integral part of this process. A team of scientists from the Indian Council of Agricultural Research-Central Potato Research Institute (ICAR-CPRI), Shimla, has come up with an innovative solution to this problem - a wind-powered insect air trap. This device addresses the shortcomings of traditional pest control methods by providing real-time insect population data. The trap is powered entirely by wind energy, making it an environmentally friendly solution that requires no power. Its unique design allows monitoring of both harmful and beneficial insects, providing a complete overview of the population in any agricultural area. “By assessing target pests at the right time, we can take necessary measures to control both pests and diseases,” says Kapil ... >>
| Random news from the Archive Pocket camera Sony HDR-GW66VE for extreme sports
03.05.2013
Action sports fans will appreciate Sony's new HDR-GW66VE camcorder. The Sony camcorder is both compact in size, easy to control and a reinforced body, protected from all sorts of misfortunes.
The Sony HDR-GW66VE camcorder meets all the requirements for such devices: it records video in Full HD resolution (1920x1080 pixels at up to 50 frames per second), has a backlit Exmor R matrix and high-strength G Lens optics. You can start shooting even during the next trick or at high speed - all you need to do is press the big red button.
Sony HDR-GW66VE can also work as a camera. The pictures are 20,4 megapixels with a fairly high level of quality. For viewing, a 3-inch tilting touchscreen display is used, which can be rotated 180 degrees.
The case of the considered camcorder is made taking into account possible frequent falls, including in mud, snow and puddles. He is not afraid of water or dust, and even a 10-degree frost is nothing to him. At the same time, the device itself is very thin and, presumably, light, although its weight is not indicated in the press release.
Sony HDR-GW66VE shoots in any weather and in any light. In the settings, you can select the format and resolution of the video for ease of viewing on a computer or the fastest possible upload to YouTube. The camera does not yet have a retail price, but it does have a release date of June 2013. Sony also promises an impressive array of accessories, including various mounts and additional housings.
|
Other interesting news:
▪ The thinnest thin-film photocell
▪ Search for axions by a dark matter hurricane
▪ Flywheel hybrid automotive technology
▪ XV-3500CB Ultra Small Gyro Sensor
▪ Vampire star discovered
News feed of science and technology, new electronics
Interesting materials of the Free Technical Library:
▪ section of the website Residual current devices. Selection of articles
▪ article Chalk to protect the file. Tips for the home master
▪ article What is dysbacteriosis? Detailed answer
▪ article Podbel hybrid. Legends, cultivation, methods of application
▪ article Transistor metal detector. Encyclopedia of radio electronics and electrical engineering
▪ article Frame and scarf. Focus Secret
Leave your comment on this article:
All languages of this page
Home page | Library | Articles | Website map | Site Reviews
www.diagram.com.ua
2000-2024
Arabic
Bengali
Chinese
English
French
German
Hebrew
Hindi
Italian
Japanese
Korean
Malay
Polish
Portuguese
Spanish
Turkish
Ukrainian
Vietnamese