Menu English Ukrainian russian Home

Free technical library for hobbyists and professionals Free technical library


ENCYCLOPEDIA OF RADIO ELECTRONICS AND ELECTRICAL ENGINEERING
Free library / Schemes of radio-electronic and electrical devices

Electric nod for winter fishing rod

Encyclopedia of radio electronics and electrical engineering / Home, household, hobby

Comments on the article Comments on the article

I wanted to find a diagram of an electric jig, rummaged through all the literature - no, but on the Internet everything is littered with high-voltage electric rods. And now, when I no longer hoped, in the Radio magazine for 1966 I found exactly what I was looking for. Found a ready-made electromagnet. Although it worked at 2 V, I decided to increase the supply voltage to 4,8 V for reliability, using 4 0,45 Ah batteries. MP42 included a 750 Ohm resistor in the emitter circuit. I also advise you to connect a capacitor of the largest possible capacity in parallel with the battery, which will enable the relay to work clearly even when the power is reduced.

Electric nodding for winter fishing rods. Electromormyshka - electric fishing rod

It is better to solder batteries to increase reliability. Corps taken from dominoes. The switch and regulator are on top. You can use a resistor with a switch. At the bottom of the structure to eliminate slipping, several protruding screws can be provided. To an elastic wire made of steel, a tongue made of steel 2 mm thick was soldered over the area of ​​the electromagnet. I drilled a through hole in the center of the case and pulled the cover with a sleeve with threaded ends.

Now a few words about work. Because most of the fish are cautious, then I put the electric jig a few meters away from me in the field of view for perch and the like, and I myself caught it with a simple winter fishing rod. The amplitude of the movement of the mormyshka was regulated by the extension of the nod. I made the response frequency 0,3-0,5 Hz, and not as indicated in the diagram.

Charging was enough for 5 fishing trips, 4 hours of work. And it’s fun for me and my friend, and the fishermen are amazed. Often shouting: "Pecking!!!". One only stood and looked gloomy, and then said that a few years ago he drowned one with a box when he fell through. He had enough industrial production for almost 1 fishing trip. And I have for the whole winter! Well, no scales to you!

Publication: cxem.net

See other articles Section Home, household, hobby.

Read and write useful comments on this article.

<< Back

Latest news of science and technology, new electronics:

Machine for thinning flowers in gardens 02.05.2024

In modern agriculture, technological progress is developing aimed at increasing the efficiency of plant care processes. The innovative Florix flower thinning machine was presented in Italy, designed to optimize the harvesting stage. This tool is equipped with mobile arms, allowing it to be easily adapted to the needs of the garden. The operator can adjust the speed of the thin wires by controlling them from the tractor cab using a joystick. This approach significantly increases the efficiency of the flower thinning process, providing the possibility of individual adjustment to the specific conditions of the garden, as well as the variety and type of fruit grown in it. After testing the Florix machine for two years on various types of fruit, the results were very encouraging. Farmers such as Filiberto Montanari, who has used a Florix machine for several years, have reported a significant reduction in the time and labor required to thin flowers. ... >>

Advanced Infrared Microscope 02.05.2024

Microscopes play an important role in scientific research, allowing scientists to delve into structures and processes invisible to the eye. However, various microscopy methods have their limitations, and among them was the limitation of resolution when using the infrared range. But the latest achievements of Japanese researchers from the University of Tokyo open up new prospects for studying the microworld. Scientists from the University of Tokyo have unveiled a new microscope that will revolutionize the capabilities of infrared microscopy. This advanced instrument allows you to see the internal structures of living bacteria with amazing clarity on the nanometer scale. Typically, mid-infrared microscopes are limited by low resolution, but the latest development from Japanese researchers overcomes these limitations. According to scientists, the developed microscope allows creating images with a resolution of up to 120 nanometers, which is 30 times higher than the resolution of traditional microscopes. ... >>

Air trap for insects 01.05.2024

Agriculture is one of the key sectors of the economy, and pest control is an integral part of this process. A team of scientists from the Indian Council of Agricultural Research-Central Potato Research Institute (ICAR-CPRI), Shimla, has come up with an innovative solution to this problem - a wind-powered insect air trap. This device addresses the shortcomings of traditional pest control methods by providing real-time insect population data. The trap is powered entirely by wind energy, making it an environmentally friendly solution that requires no power. Its unique design allows monitoring of both harmful and beneficial insects, providing a complete overview of the population in any agricultural area. “By assessing target pests at the right time, we can take necessary measures to control both pests and diseases,” says Kapil ... >>

Random news from the Archive

Iron Man Boots 24.12.2022

Scientists have invented Iron Man boots. They provide additional opportunities for walking.

Engineers at the Biomechatronics Lab at Stanford University have created an automated exoskeleton that gives people a boost when they walk.

Robotics expert Patrick Slade said: "Essentially, these are motorized shoes. By replacing the calf function with a motor, we can actually speed up the stride and help people walk easier and faster."

The new exo-boot is worn over regular shoes, and the sensors are attached to the calf muscle using a brace and carbon fiber cables. When a person walks, a motor placed behind the shin pulls on a cable connected to the shoe, which allows the person to effortlessly (or with significantly less effort) lift the foot off the ground. However, these futuristic walking devices are far from universal - they first need to properly study the owner.

The boots are equipped with an artificial intelligence unit that collects and analyzes data to understand how the wearer walks, and then adapt their assistance to his unique gait.

Other interesting news:

▪ Flies are more dangerous than thought

▪ Voltage regulator ADM8839

▪ Winchester Systems FlashDisk FX Disk Arrays

▪ Mokacam Miniature Modular Camera

▪ Garmin Smart Bike Headlight

News feed of science and technology, new electronics

 

Interesting materials of the Free Technical Library:

▪ site section Electrical work. Article selection

▪ article Boil milk and honey. Popular expression

▪ article What are tapeworms? Detailed answer

▪ article Lungwort dark. Legends, cultivation, methods of application

▪ article Prefix for measuring low resistances. Encyclopedia of radio electronics and electrical engineering

▪ article Charger on trinistor. Encyclopedia of radio electronics and electrical engineering

Leave your comment on this article:

Name:


Email (optional):


A comment:





All languages ​​of this page

Home page | Library | Articles | Website map | Site Reviews

www.diagram.com.ua

www.diagram.com.ua
2000-2024