Menu English Ukrainian russian Home

Free technical library for hobbyists and professionals Free technical library


ENCYCLOPEDIA OF RADIO ELECTRONICS AND ELECTRICAL ENGINEERING
Free library / Schemes of radio-electronic and electrical devices

Power amplifier on a TDA1562 chip (55 watts). Encyclopedia of radio electronics and electrical engineering

Free technical library

Encyclopedia of radio electronics and electrical engineering / Transistor power amplifiers

Comments on the article Comments on the article

The amplifier is built on a microcircuit of the bourgeois company Philips TDA1562, in which the so-called H mode is implemented. Its essence is that up to a certain output power value (approximately 20 watts), the amplifier operates in mode B. If the output power grows further, a smart boost circuit is turned on. voltage at the output stage and thus allows you to swing the amplifier up to a maximum power of 70 watts.

Well, at least that's how it looks in theory.

The main characteristics are as follows:

Supply voltage 14,4
Current consumption in silent mode, mA 110
Input resistance, kOhm 150
Rated output power (KG=0,5%), W 55
Maximum output power (KG=10%), W 70
Reproducible frequency range, Hz 20 20000 ...

Inclusion circuit

Power amplifier on a TDA1562 chip (55 watts)

Generally speaking, this IC is recommended for use in an entry-level subwoofer in a car. And the above scheme is optimized for just such an application. Although, of course, no one bothers to reproduce the full signal with its help.

Capacitors C4 and C5 work as power storage devices for the functioning of the very smart circuit that ensures the operation of mode H. The HL1 LED - diagnostic - turns on in case of emergency conditions of the microcircuit - overheating, short circuit in the load and very large signal distortions. It is recommended to supply power to the amplifier directly from the car battery, and with as thick wires as possible.

About details

Designation in the diagram Nominal
R1, R2, R3 10kOhm
R4 1kOhm
C1, C2 0,22uF
C3 10uFx16V
C4, C5 10000uFx25V
C6 0,1uF
C7 4700uFx25V
VT1 KT3107
HL1 any
DA1 TDA1562

Capacitors C1 and C2 must be film, for example K73-17 or any other, but in no case ceramic. Electrolytic capacitors can also be taken with an operating voltage of 16 volts, but the reliability of such a solution will be lower. Transistor VT1 can be replaced by KT361 with any letter.

You can take the printed circuit board here.

Publication: radiokot.ru

See other articles Section Transistor power amplifiers.

Read and write useful comments on this article.

<< Back

Latest news of science and technology, new electronics:

Machine for thinning flowers in gardens 02.05.2024

In modern agriculture, technological progress is developing aimed at increasing the efficiency of plant care processes. The innovative Florix flower thinning machine was presented in Italy, designed to optimize the harvesting stage. This tool is equipped with mobile arms, allowing it to be easily adapted to the needs of the garden. The operator can adjust the speed of the thin wires by controlling them from the tractor cab using a joystick. This approach significantly increases the efficiency of the flower thinning process, providing the possibility of individual adjustment to the specific conditions of the garden, as well as the variety and type of fruit grown in it. After testing the Florix machine for two years on various types of fruit, the results were very encouraging. Farmers such as Filiberto Montanari, who has used a Florix machine for several years, have reported a significant reduction in the time and labor required to thin flowers. ... >>

Advanced Infrared Microscope 02.05.2024

Microscopes play an important role in scientific research, allowing scientists to delve into structures and processes invisible to the eye. However, various microscopy methods have their limitations, and among them was the limitation of resolution when using the infrared range. But the latest achievements of Japanese researchers from the University of Tokyo open up new prospects for studying the microworld. Scientists from the University of Tokyo have unveiled a new microscope that will revolutionize the capabilities of infrared microscopy. This advanced instrument allows you to see the internal structures of living bacteria with amazing clarity on the nanometer scale. Typically, mid-infrared microscopes are limited by low resolution, but the latest development from Japanese researchers overcomes these limitations. According to scientists, the developed microscope allows creating images with a resolution of up to 120 nanometers, which is 30 times higher than the resolution of traditional microscopes. ... >>

Air trap for insects 01.05.2024

Agriculture is one of the key sectors of the economy, and pest control is an integral part of this process. A team of scientists from the Indian Council of Agricultural Research-Central Potato Research Institute (ICAR-CPRI), Shimla, has come up with an innovative solution to this problem - a wind-powered insect air trap. This device addresses the shortcomings of traditional pest control methods by providing real-time insect population data. The trap is powered entirely by wind energy, making it an environmentally friendly solution that requires no power. Its unique design allows monitoring of both harmful and beneficial insects, providing a complete overview of the population in any agricultural area. “By assessing target pests at the right time, we can take necessary measures to control both pests and diseases,” says Kapil ... >>

Random news from the Archive

Food for everyone 25.10.2002

Margareta Bergman of the Swedish University of Agricultural Sciences says that when moose nibble on trees, it stimulates the growth of new branches.

This conclusion was led by an experiment in which one group of young willows was trimmed with secateurs, and in another group, after the same haircut, cuts of branches were smeared with elk saliva. The third group was not trimmed in any way. It is known that pruning plants enhances their growth. After 15 weeks, it turned out that simple pruning increased the number of new shoots compared to control plants by 20 percent, and pruning and saliva smearing increased the number of new branches by as much as 110 percent.

Which component of saliva acts this way is not yet known. But if it can be isolated and synthesized, then, perhaps, gardens will be sprayed with this drug.

M. Bergman notes that some species of plants, in response to their eating by animals, have developed toxic or unpleasant substances in themselves, while others, apparently, have learned to quickly compensate for the damage.

Other interesting news:

▪ Ultrasonic dry cleaning at home

▪ Axial Higgs mode

▪ Pocket Ultrasound

▪ Bad mood due to bad mood

▪ Electric backpacks for soldiers

News feed of science and technology, new electronics

 

Interesting materials of the Free Technical Library:

▪ site section Lightning protection. Article selection

▪ article How did you come to such a life? Popular expression

▪ article Why is Friedrich Nietzsche attributed to anti-Semitic views? Detailed answer

▪ article An employee of stationary and mobile gas stations, oil depots, fuel and lubricants warehouses. Standard instruction on labor protection

▪ article Refinement of the automotive voltage regulator 59.3702-01. Encyclopedia of radio electronics and electrical engineering

▪ article Panoramic view on TV. Encyclopedia of radio electronics and electrical engineering

Leave your comment on this article:

Name:


Email (optional):


A comment:





All languages ​​of this page

Home page | Library | Articles | Website map | Site Reviews

www.diagram.com.ua

www.diagram.com.ua
2000-2024